1. 安裝前，一定要檢查各零件是否良好，潤滑油是否上足，螺栓有無鬆動，與其有關技術數據是否相符。
2. 安裝時，一定要保持基礎布置平麵水平180°;啟閉機底座與基礎布置平麵的接觸麵積要達到90%以上;螺杆軸線要垂直於閘台上橫梁的水平麵;要與閘板吊耳孔吻合垂直，避免螺杆傾斜，造成局部受力而損壞機件。
3. 安an裝zhuang後hou，一yi定ding要yao作zuo試shi運yun行xing，一yi作zuo無wu載zai荷he試shi驗yan，即ji讓rang螺luo杆gan作zuo兩liang個ge行xing程cheng，聽ting其qi有you無wu異yi常chang聲sheng響xiang，檢jian測ce安an裝zhuang是shi否fou符fu合he技ji術shu要yao求qiu。二er作zuo載zai荷he試shi驗yan，在zai額e定ding載zai荷he下xia，作zuo兩liang個ge行xing程cheng，觀guan察cha螺luo杆gan與yu閘zha門men的de運yun行xing情qing況kuang，有you無wu異yi常chang現xian象xiang。確que認ren無wu誤wu後hou，方fang可ke正zheng式shi運yun行xing。在zai載zai荷he運yun行xing一yi段duan時shi間jian後hou，要yao進jin行xing首shou次ci保bao養yang，把ba機ji內nei新xin機ji件jian磨mo擦ca產chan生sheng的de金jin屬shu沫mo特te別bie是shi螺luo杆gan、螺母、渦輪、渦杆，要輕洗幹淨，塗上潤滑油，密封嚴實，繼續使用。
1. Before installation, it is necessary to check whether the parts are in good condition, whether the lubricating oil is sufficient, whether the bolts are loose, and whether the relevant technical data are consistent.
2. When installing, it is necessary to keep the level of foundation layout 180 degrees; the contact area between the base of hoist and the plane of foundation layout should be more than 90%; the axis of screw should be perpendicular to the horizontal plane of the cross beam on the gate platform; and it should be vertical to the ear hole of the gate plate to avoid the inclination of screw, which will cause local stress and damage to the machine parts.
3. After installation, it is necessary to make a trial run. As soon as a load-free test is carried out, the screw is allowed to make two journeys, listen to its abnormal sound, and check whether the installation meets the technical zuchet.75ix.com qidongjt.89ix.com bopiji.89ix.com xuanqieji.89ix.com jianqiejij.89ix.com tongshizi.89ix.comrequirements. The second is the load test. Under the rated load, two strokes are made to observe the operation of screw and gate, and whether there are any abnormal phenomena. Only after confirmation is correct can it be officially operated. After a period of load operation, the first maintenance should be carried out. The metal foam produced by friction of new parts in the machine, especially screw, nut, turbine and scroll, should be cleaned lightly, coated with lubricant, sealed tightly, and continued to use.
